4.
Tighten the thumbscrews at each end of the Routing Engine.
5.
You can verify correct Routing Engine functioning by issuing the
show chassis routing-engine
command, described in “Maintaining the M7i Routing
Engine” on page 72.
Figure 40: Installing the Routing Engine
Related
Documentation
Preventing Electrostatic Discharge Damage to an M7i Router on page 128
•
•
M7i Chassis Description on page 6
•
M7i Routing Engine Description on page 18
•
Maintaining the M7i Routing Engine on page 72
Replacing the Routing Engine Interface Port Cables
The Routing Engine is located on the front of the router, as shown in Figure 1 on page 6.
It houses the Routing Engine interface ports, which accept connections to external
management devices.
To replace the cables connecting to the Routing Engine interface ports, perform the
following procedures:
•
Replacing the Management Ethernet Cable on page 99
•
Replacing the Console or Auxiliary Cable on page 100
Replacing the Management Ethernet Cable
To replace the management Ethernet cable:
1.
Press the tab on the connector on the management Ethernet cable and pull the
connector straight out of the port. Figure 41 on page 99 shows the connector.
2.
Disconnect the cable from the network device.
3.
Plug one end of the replacement Ethernet cable into the
MGMT
port (see Figure 42
on page 100).
4.
Plug the other end of the cable into the network device.
Figure 41: Routing Engine Ethernet Cable Connector
99
Copyright © 2010, Juniper Networks, Inc.
Chapter 15: Replacing M7i Hardware Components
All manuals and user guides at all-guides.com
