Juniper JUNOSE 11.2.X IP SERVICES, Configuration Manual

Page: 78 / 356

•
For field descriptions, see the show commands for the individual routing protocols in
their respective Configuration Guide chapters.
•
Example
host1# show ip protocols
Routing Protocol is “ bgp 1”
Default local preference is 100
IGP synchronization is enabled
Always compare MED is disabled
Router flap damping is disabled
Administrative Distance: external 20 internal 200 local 200
Neighbor(s):
No neighbors are configured
Routing for Networks:
Routing Protocol is “ ospf 255” with Router ID 100.100.100.1
Distance is 110
Address Summarization:
None
Routing for Networks:
Routing Protocol is “ rip”
Router Administrative State: enable
System version RIP1: send = 1, receive = 1 or 2
Update interval: 30 seconds
Invalid after: 180 seconds
hold down time: 120 seconds
flushed interval: 300 seconds
Filter applied to outgoing route update is not set
Filter applied to incoming route update is not set
No global route map
Distance is 120
Interface Tx Rx Auth
Routing for Networks:
10.2.1.0/255.255.255.0
•
See show ip protocols.
show ip redistribute
•
Use to display configured route redistribution policy.
•
Field descriptions
•
To—Protocol into which routes are distributed
•
From—Protocol from which routes are distributed
•
status—Redistribution status
•
route map number—Number of the route map
•
Example
Copyright © 2010, Juniper Networks, Inc. 52
JunosE 11.2.x IP Services Configuration Guide