Juniper JUNOSE 11.2.X IP SERVICES, Configuration Manual

Page: 45 / 356

set route-type
•
Use to set the routes of the specified type (internal, internal-intra, internal-inter, or
external).
•
Example
host1(config-route-map)# set route-type internal
•
Use the no version to delete the set clause from a route map.
•
See set route-type.
set tag
•
Use to set the tag value of the destination routing protocol.
•
Example
host1(config-route-map)# set tag 23
•
Use the no version to delete the set clause from a route map.
•
See set tag.
set weight
•
Use to specify the BGP weight for the routing table.
•
The weights assigned with the set weight command in a route map override the weights
assigned using the neighbor weight and neighbor filter-list weight commands.
•
Example
host1(config-route-map)# set weight 200
•
Use the no version to delete the set clause from a route map.
•
See set weight.
Match Policy Lists
Match policy lists are very similar to route maps. However, unlike route maps, match
policy lists can contain only match clauses and no set clauses.
You create match policy lists and then reference those lists within route maps. Because
match policy lists share the same match clauses with route maps, they function the same
way, and you can use the same match commands when you create your match policy
lists.
NOTE: For descriptions of all route map match clauses, see “Route Maps” on page 4
.
As in route maps, the match clauses in match policy lists contain permit and deny
statements. When you reference a match policy list within a route map, the route map
19 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring Routing Policy