Juniper JUNOSE 11.2.X IP SERVICES, Configuration Manual

Page: 170 / 356

host1(config-if)# tunnel destination identity branch245.customer77.isp.net
•
Example 3
host1(config-if)# tunnel destination identity user4919@branch245.customer77.isp.net
•
Use the no version to remove the address.
•
See tunnel destination.
tunnel lifetime
•
Use to set the renegotiation time of the SAs in use by this tunnel.
•
To configure the lifetime in number of seconds, use the seconds keyword to specify
the lifetime in the range 1800–864000.The default value is 28800 seconds.
•
To configure the lifetime in amount of traffic, use the kilobytes keyword to specify the
lifetime in the range 102400–4294967295. The default is an unlimited volume.
•
If you include the seconds keyword as the first keyword on the command line, you can
also include the kilobytes keyword on the same line.
•
Before either the volume of traffic or number of seconds limit is reached, the SA is
renegotiated, which ensures that the tunnel does not go down during renegotiation.
•
Example
host1(config-if)# tunnel lifetime seconds 48000 kilobytes 249000
•
Use the no version to restore the default lifetime (28800 seconds) and an unlimited
volume.
•
See tunnel lifetime.
tunnel local-identity
Use to configure the local identity (selector) of the tunnel. Specify the identity using
one of the following keywords:
•
•
address —Specifies an IP address as the local identity
•
subnet —Specifies a subnet as the local identity
•
range —Specifies a range of IP addresses as the local identity
•
Example 1
host1(config-if)# tunnel local-identity range 10.10.1.1 10.10.2.1
•
Example 2
host1(config-if)# tunnel local-identity subnet 10.10.1.1 255.255.255.0
•
Use the no version to restore the default identity, which is subnet 0.0.0.00.0.0.0
•
See tunnel local-identity.
tunnel mtu
•
Use to set the MTU size for the tunnel.
•
Example
Copyright © 2010, Juniper Networks, Inc. 144
JunosE 11.2.x IP Services Configuration Guide