Juniper JUNOSE 11.2.X IP SERVICES, Configuration Manual

Page: 216 / 356

•
Use to create the GSMP output label associated with the interface. In addition to the
label, this command also specifies the access node using the neighbor keyword.
•
Example
host1(config-if)# l2c end-user-id out_subscriber_port_6 neighbor ACCESS_NODE_1
•
Use the no version to remove the output label association.
•
See l2c end-user-id.
l2c max-branches
•
Use to specify the maximum number of branches the ANCP end user can have.
•
Example
host1(config-if)# l2c max-branches 5
•
Use the no version to return the maximum number of branches to its default value,
unlimited branches.
•
See l2c max-branches.
l2c peer-attachment-id
•
Use to create the GSMP input label associated with the interface.
•
Example
host1(config-if)# l2c peer-attachment-id in_multicast_port_5
•
Use the no version to remove the input label association.
•
See l2c peer-attachment-id.
Configuring ANCP Neighbors
From the L2C Configuration mode (config-l2c), you can access the L2C Neighbor
Configuration mode, from which you can create and manage ANCP neighbors.
Accessing L2C Neighbor Configuration Mode for ANCP
Use the neighbor command to create an ANCP neighbor and access the L2C Neighbor
Configuration (config-l2c-neighbor) mode.
neighbor
•
Use to create an ANCP neighbor and access the L2C Neighbor Configuration
(config-l2c-neighbor) mode.
•
Example
host1(config-l2c)# neighbor ACCESS-NODE-1
host1(config-l2c-neighbor)#
•
Use the no version to remove a specific ANCP neighbor configuration or, by omitting
the neighbor name, all ANCP neighbor configurations.
•
See neighbor.
Copyright © 2010, Juniper Networks, Inc. 190
JunosE 11.2.x IP Services Configuration Guide