Jungheinrich EKS 308, Operating Instructions Manual

Page: 82 / 99

F 11
0708
.GB
6.5 Hydraulic oil
– Prepare the truck for maintenance and repairs
M
Oil must never be allowed to enter the drainage system or the soil. Used oil must be
preserved until it can be disposed of in the correct manner.
M
Only fill or drain hydraulic oil when the mast is completely lowered.
Remove the electronic compartment cover at the back.
Draining oil:
Suction off the hydraulic oil with the
discharge filter removed (4). If this is not
possible, the hydraulic oil can be drained
from the bottom of the hydraulic
reservoir after the oil drain screw (6) has
been unscrewed.
Adding oil:
Screw in the oil drain screw (6).
Replenish with new hydraulic oil up to
the Max. mark on the dipstick (7). Screw
the discharge filter backon.
F
Check which hydraulic oil is being
added. If Plantohyd 22 SBIOhydraulic oil is being used, the
warning: “Only add BIO hydraulic oil” (8) will be on the
hydraulic reservoir. In this case you may only use Hydrauliköl
„Plantohyd 22 S BIOhydraulic oil to fill the hydraulic reservoir.
F
You cannot change from the Plantohyd 22 S BIO hydraulic oil to HLP D22. The same
applies to changing from HLP D22 hydraulic oil to Plantohyd 22 S BIOhydraulic oil.
Furthermore, you cannot mix HLP D22 hydraulic oilt Plantohyd 22 SBIO hydraulic oil.
Checking the hydraulic oil level
When the mast is fully lowered, check that the hydraulic oil level is between the min.
and max. markings on the dipstick (7). If not, add new hydraulic oil.
6.6 Hydraulic hoses
Hose lines must be replaced every six years, see Safety Regulations for Hydraulic
Hose Lines ZH 1/74.
4
6
7
8
F 11
0708
.GB
6.5 Hydraulic oil
– Prepare the truck for maintenance and repairs
M
Oil must never be allowed to enter the drainage system or the soil. Used oil must be
preserved until it can be disposed of in the correct manner.
M
Only fill or drain hydraulic oil when the mast is completely lowered.
Remove the electronic compartment cover at the back.
Draining oil:
Suction off the hydraulic oil with the
discharge filter removed (4). If this is not
possible, the hydraulic oil can be drained
from the bottom of the hydraulic
reservoir after the oil drain screw (6) has
been unscrewed.
Adding oil:
Screw in the oil drain screw (6).
Replenish with new hydraulic oil up to
the Max. mark on the dipstick (7). Screw
the discharge filter backon.
F
Check which hydraulic oil is being
added. If Plantohyd 22 SBIOhydraulic oil is being used, the
warning: “Only add BIO hydraulic oil” (8) will be on the
hydraulic reservoir. In this case you may only use Hydrauliköl
„Plantohyd 22 S BIOhydraulic oil to fill the hydraulic reservoir.
F
You cannot change from the Plantohyd 22 S BIO hydraulic oil to HLP D22. The same
applies to changing from HLP D22 hydraulic oil to Plantohyd 22 S BIOhydraulic oil.
Furthermore, you cannot mix HLP D22 hydraulic oilt Plantohyd 22 SBIO hydraulic oil.
Checking the hydraulic oil level
When the mast is fully lowered, check that the hydraulic oil level is between the min.
and max. markings on the dipstick (7). If not, add new hydraulic oil.
6.6 Hydraulic hoses
Hose lines must be replaced every six years, see Safety Regulations for Hydraulic
Hose Lines ZH 1/74.
4
6
7
8