Jungheinrich EKS 308, Operating Instructions Manual

Page: 27 / 99

0306
.GB
C 4
3.1 Basic truck transport safety
M
The mast must only be disassembled by the manufacturer’s authorised service
department.
To ensure secure transport of a disassembled EKS 308, use the attachment points
for fastening/quick release belts.
Z
Only use fastening / quick release belts with a rated capacity of >5 tonnes.
M
When transporting, always relieve the drive wheel by placing the entire surface of a
wooden beam (8) underneath the counterweight (minimum chassis width). In
addition, secure the load wheels with wedges (10).
M
If the truck’s battery is supplied in the chassis, disconnect the battery.
Fastening/quick release belts (9, 11) should be attached to at least 4 different lorry/
truck eyes (7).
Fastening/quick release belts placed over “sharp” edges must be protected by a
suitable support material , e. g. foam.
To ensure secure transport of an EKS 308, use the following prescribed attachment
points for fastening/quick release belts.
– The fastening/quick release belt (9) is tensioned above the battery compartment.
To do this, remove the side parts and pack them separately.
M
Note the cable routing and cover sharp edges with a suitable material.
– The fastening/quick release belt (11) above the upper chassis section is routed
behind the two mast attachment bars (6).
6
11
7 10 9 8 7
0306
.GB
C 4
3.1 Basic truck transport safety
M
The mast must only be disassembled by the manufacturer’s authorised service
department.
To ensure secure transport of a disassembled EKS 308, use the attachment points
for fastening/quick release belts.
Z
Only use fastening / quick release belts with a rated capacity of >5 tonnes.
M
When transporting, always relieve the drive wheel by placing the entire surface of a
wooden beam (8) underneath the counterweight (minimum chassis width). In
addition, secure the load wheels with wedges (10).
M
If the truck’s battery is supplied in the chassis, disconnect the battery.
Fastening/quick release belts (9, 11) should be attached to at least 4 different lorry/
truck eyes (7).
Fastening/quick release belts placed over “sharp” edges must be protected by a
suitable support material , e. g. foam.
To ensure secure transport of an EKS 308, use the following prescribed attachment
points for fastening/quick release belts.
– The fastening/quick release belt (9) is tensioned above the battery compartment.
To do this, remove the side parts and pack them separately.
M
Note the cable routing and cover sharp edges with a suitable material.
– The fastening/quick release belt (11) above the upper chassis section is routed
behind the two mast attachment bars (6).
6
11
7 10 9 8 7