Jungheinrich EKS 308, Operating Instructions Manual

Page: 77 / 99

0708
.GB
F 6
e) WG: wire guidance trucks
Maintenance intervals
Standard =
t
W A B C
Lift
mechanism: 10.1 Clean rollers, guide rollers and contact surfaces in the
mast sections and apply grease.
M
Warning: Danger of crashing!
t
10.2 Check mast attachments (bearings and retaining
screws)
t
10.3 Check lift chains and chain guide for wear, adjust and
lubricate
t
10.4 Lubricate lift chains
t
10.5 Visually inspect rollers, slide pieces and stops
t
10.6 Check forks and fork carriage for wear and damage
t
10.7 Check pallet clamp for wear and
damage
t
Safety
Devices: 12.1 Check safety restraint harness for damage and wear,
and test operation
t
12.2 Check receptacle eye on overhead guard for damage
and wear, and test operation
t
12.3 Check legibility of notices on safety restraint belt.
t
Lubrication: 13.1 Lubricate the truck according to the lubrication schedule
t
General
Measure-
ments: 14.1 Check electrical system for frame leakage
t
14.2 Test travel speed and braking distance
t
14.3 Test lift and lowering speeds
t
14.4 Test safety devices and cutouts
t
14.5 WG: Measure the current in the guidance wire, adjust if
necessary e)
t
14.6 Test travel on the guidance wire, check maximum
deviation and adjust if necessary e)
t
14.7 Check tracking mode on the guidance wire for aisle
tracking e)
t
14.8 Check wire guidance EMERGENCY STOP operatione)
t
Demon-
stration: 15.1 Test run with rated load
t
15.2 When maintenance is complete, present the truck to the
responsible person.
t
0708
.GB
F 6
e) WG: wire guidance trucks
Maintenance intervals
Standard =
t
W A B C
Lift
mechanism: 10.1 Clean rollers, guide rollers and contact surfaces in the
mast sections and apply grease.
M
Warning: Danger of crashing!
t
10.2 Check mast attachments (bearings and retaining
screws)
t
10.3 Check lift chains and chain guide for wear, adjust and
lubricate
t
10.4 Lubricate lift chains
t
10.5 Visually inspect rollers, slide pieces and stops
t
10.6 Check forks and fork carriage for wear and damage
t
10.7 Check pallet clamp for wear and
damage
t
Safety
Devices: 12.1 Check safety restraint harness for damage and wear,
and test operation
t
12.2 Check receptacle eye on overhead guard for damage
and wear, and test operation
t
12.3 Check legibility of notices on safety restraint belt.
t
Lubrication: 13.1 Lubricate the truck according to the lubrication schedule
t
General
Measure-
ments: 14.1 Check electrical system for frame leakage
t
14.2 Test travel speed and braking distance
t
14.3 Test lift and lowering speeds
t
14.4 Test safety devices and cutouts
t
14.5 WG: Measure the current in the guidance wire, adjust if
necessary e)
t
14.6 Test travel on the guidance wire, check maximum
deviation and adjust if necessary e)
t
14.7 Check tracking mode on the guidance wire for aisle
tracking e)
t
14.8 Check wire guidance EMERGENCY STOP operatione)
t
Demon-
stration: 15.1 Test run with rated load
t
15.2 When maintenance is complete, present the truck to the
responsible person.
t