Jungheinrich EKS 308, Operating Instructions Manual

Page: 75 / 99

0708
.GB
F 4
4 EKS 308 maintenance checklist
Maintenance intervals
Standard =
t
W A B C
Chassis/
Super-
structure: 1.1 Check all load bearing components for damage
t
1.2 Check screw connections
t
1.3 Test the operator platform and check for damage
t
1.4 Check that identification points, data plates and
warnings are legible and replace if necessary
t
1.5 Check tilt safety devices are present and secure
t
1.7 Make sure decals are present, legible and valid
t
1.8 Check battery panel and sides are secure
t
1.9 Test the operation of the battery panel attachment and
check for damage
t
Drive: 2.1 Lubricate the bearing point between the drive
motor and transmission
t
2.2 Check transmission for noise and leakage
t
2.3 Change transmission oil
t
Wheels: 3.1 Check wheels for wear and damage
t
3.2 Check and lubricate suspension and attachment
t
Steering: 4.1 Test wheel position indicator
t
4.2 Check the distance between the guide rollers and the
rail guidance over the entire length of the rails. The play
between the two guide rollers and the rails (measured
over the axle) should be 0-5 mm. The rollers should not
jam.
t
Brake
system: 5.1 Test operation and settings
t
5.2 Check the brake lining wear
t
5.3 Check brake mechanism, adjust and lubricate if
necessary
t
0708
.GB
F 4
4 EKS 308 maintenance checklist
Maintenance intervals
Standard =
t
W A B C
Chassis/
Super-
structure: 1.1 Check all load bearing components for damage
t
1.2 Check screw connections
t
1.3 Test the operator platform and check for damage
t
1.4 Check that identification points, data plates and
warnings are legible and replace if necessary
t
1.5 Check tilt safety devices are present and secure
t
1.7 Make sure decals are present, legible and valid
t
1.8 Check battery panel and sides are secure
t
1.9 Test the operation of the battery panel attachment and
check for damage
t
Drive: 2.1 Lubricate the bearing point between the drive
motor and transmission
t
2.2 Check transmission for noise and leakage
t
2.3 Change transmission oil
t
Wheels: 3.1 Check wheels for wear and damage
t
3.2 Check and lubricate suspension and attachment
t
Steering: 4.1 Test wheel position indicator
t
4.2 Check the distance between the guide rollers and the
rail guidance over the entire length of the rails. The play
between the two guide rollers and the rails (measured
over the axle) should be 0-5 mm. The rollers should not
jam.
t
Brake
system: 5.1 Test operation and settings
t
5.2 Check the brake lining wear
t
5.3 Check brake mechanism, adjust and lubricate if
necessary
t