Jungheinrich EKS 308, Operating Instructions Manual

Page: 70 / 99

E 33
0306
.GB
5.9.2 Adjusting the steering angle
F
The battery must be disconnected when
adjusting the steering angle.
– Remove the electronic compartment
cover at the back.
Using an Allen switch set the steered
wheel to the required direction via the
screw in the steering motor (72).
Z
When setting an angle greater than 4
degrees it is advisable to discharge the
wheel by raising/jacking up the truck.
5.9.3 Emergency recovery in drive
direction:
– Remove the electronic compartment cover at the back.
– Lower the operator position carriage and release the magnetic brake.
– Guide the tow rope (75), tow force > 5 tonnes, around the counterweight (73) by the
left or right sides of the antenna (74).
M
Note the wire routing in the drive compartment and the antenna (74)!
– Carefully and slowly pull the truck out of the narrow aisle.
F
After recovery, prevent the truck from accidentally moving.
To do this, unscrew the setscrews on the magnetic brake above the drive motor. If
the brake is not working, place wedges underneath the wheels of the truck to prevent
it from moving.
72
73
74
75
E 33
0306
.GB
5.9.2 Adjusting the steering angle
F
The battery must be disconnected when
adjusting the steering angle.
– Remove the electronic compartment
cover at the back.
Using an Allen switch set the steered
wheel to the required direction via the
screw in the steering motor (72).
Z
When setting an angle greater than 4
degrees it is advisable to discharge the
wheel by raising/jacking up the truck.
5.9.3 Emergency recovery in drive
direction:
– Remove the electronic compartment cover at the back.
– Lower the operator position carriage and release the magnetic brake.
– Guide the tow rope (75), tow force > 5 tonnes, around the counterweight (73) by the
left or right sides of the antenna (74).
M
Note the wire routing in the drive compartment and the antenna (74)!
– Carefully and slowly pull the truck out of the narrow aisle.
F
After recovery, prevent the truck from accidentally moving.
To do this, unscrew the setscrews on the magnetic brake above the drive motor. If
the brake is not working, place wedges underneath the wheels of the truck to prevent
it from moving.
72
73
74
75