41
8-2
BODY ATTACHMENT/FINAL FITTING
........... 2 pcs
3 x 15 mm Socket Head Bolt
.......................... 2 pcs
3 mm Flat Washer
.................. 4 pcs
Rubber Grommet
Note: It will be neccessary to remove the tail case
assembly to install the rear body section.
Do not loosen the tail boom or change belt
tension as this must remain set prior to
rear body attachment. Trim the tail guide
clamp to the edge of the square guide to
allow proper clearance to the rear body.
Trim excess material from the rear guide clamp
for proper body clearance.
Use Threadlock
3 mm Flat Washer (2)
3 x 15 mm Socket Head Bolt (2)
Standoffs (2)
Rear Body
(Apply decals prior to final attachment.)
Drill 2
1
/
8
" holes after the
rear body has been fitted so
that the holes will match the
standoff positions.
*Note: Prior to drilling the two rearward canopy
mounting holes, it will be neccessary to test fit
the body for proper mainshaft/swashplate
clearance. Please note that the final hole positions
will vary from the marking on the front body half.
Drill 4
15
/
64
" holes and insert
rubber grommets as shown.
Rubber Grommet (6)
Trim the body as
needed for proper
muffler clearance.
*
Remove tail
case assembly.
JRP9012.46 Robinson R22 Manual 10/6/00 5:06 PM Page 41
