9
1-3
ELEVATOR ARM ASSEMBLY
Swashplate A Arm
JR Logo Direction
Elevator Arm
11 mm Long Ball Arm
3 mm Flat Washer
Swashplate A Arm
Edge of Work Bench
Elevator Arm
Tap in gently with
a small hammer.
Elevator Arm Pin
3 mm Lock Nut
Caution: Be sure to note the correct Swashplate A Arm
installation direction.
Elevator Arm
Marked Side Out
Swashplate
A Arm
1-4
FUEL TANK ASSEMBLY
3 mm Lock Nut
11 mm Long Ball Arm
Elevator Arm Pin
3 mm Flat Washer
...................... 1 pc
......... 1 pc
.................. 1 pc
.............................. 1 pc
7 mm Nut
........... 1 pc
7 x 12 x 1 mm Washer
........... 1 pc
Silicone Tube (small) — Use tubing
included in seperate package in kit.
Nipple
Medium Silicone Fuel
Tubing (not included) —
Connect to Engine Carburetor
1. Cut the small silicone fuel tubing (included)
to a length of 58 mm. Next, connect the fuel
tank clunk, nipple, and medium silicone fuel
tubing (not included) as shown above.
Fuel Tank Grommet
2. Insert the assembly into the fuel tank
opening so that the nipple is inside the tank.
Next, slide the fuel tank grommet over the
medium fuel tubing.
Make sure grommet is fully seated.
Pull out until nipple threads are exposed.
3. Inset the fuel tank grommet into
the fuel tank opening, making
sure that it is fully seated.
4. Pull the medium
fuel tubing out of
the fuel tank unit
the threads of the
fuel tank nipple
are exposed.
7 mm Nut
7 x 12 x 1 mm Washer
Use two wrenches if necessary
to secure tank nipple.
5. Remove the medium silicone fuel tubing
from the nipple and secure the nipple to the
fuel tank using the 7 x 12 x 1 mm washer
and 7 mm nut supplied. Be sure to secure
this assembly firmly to avoid leakage.
6.Complete Assembly
JRP9012.46 Robinson R22 Manual 10/6/00 5:05 PM Page 9
