29
6-1
SERVO INSTALLATION
RADIO INSTALLATION SUGGESTIONS
Be sure to install 4 rubber servo grommets
and eyelets to each servo prior to
installation. When securing the servos to
the helicopter, be sure not to over-tighten
the mounting screws.
When adjusting control rods, be sure to
adjust each universal link the same amount
so as not to unthread one link too far.
Be sure to keep all servo lead wires, etc.,
away from all servo arms, rods, and sharp
edges of the helicopter’s mechanics. after
final installation, group these wires together,
as indicated, using the small nylon wire ties
and the nylon spiral tubing included with
this kit.
2.6 x 12 mm Self Tapping Screw
.............. 20 pcs
2.6 mm Flat Washer
................................. 20 pcs
Servo Mounting Plates “B”
..................... 8 pcs
Servo Mounting Plates “B”
Left Servo
2.6 x 12 mm Self
Tapping Screw
2.6 mm Flat Washer
Servo Mounting
Plates “B”
Tail Rotor Servo
Right Servo
2.6 x 12 mm
Self Tapping Screws
2.6 mm Flat Washer
Throttle Servo
*Front Servo
Note: Before installing servos, it’s suggested that the
servo mounting plates “B” be secured to the
inside frame position using a small amount of
CA adhesive. This will ease servo installation.
*Install the front servo into the main frame location as shown.
JRP9012.46 Robinson R22 Manual 10/6/00 5:05 PM Page 29