38
7-7
TAIL CONTROL ROD SERVO CONNECTION
................1 pc
2 x 8 mm Flat Head Screw
......................1 pc
Steel Joint Ball
.......................... 1 pc
2 mm Hex Nut
Note: Make certain that the tail rotor servo is in
the neutral or hover position before
securing the servo horn to the servo.
Note: Check that the tail control rod can slide through the tail control rod guides
smoothly before connecting it to the servo. If resistance is felt, rotate the tail
control rod guides slightly until the control rod slides smoothly.
Tail Control Lever Position
at Center Stick
90°
2 x 8 mm Flat
Head Screw
Use Threadlock
2 mm Hex Nut
Servo Horn
Servo Reversing Directions
JR Reverse
Futaba
Reverse
Servo Reversing Directions
JR Reverse
Futaba
Normal
Steel Joint Ball
Right
Left
90°
12.5 mm
Use this hole
JR
Futaba
Servo Horn Hole Selection
Use blue Threadlock
JRP9012.46 Robinson R22 Manual 10/6/00 5:06 PM Page 38
