Chipping
Before feeding, pull up engine to full speed. Push control handle to feeding
position
Note, Two adults are supposed to operate together, in case of any
emergency.
Feeding
1. Pick up branches, make you can stand straight and walk freely, put the cut
side into roller. For the first 4-8 hours with new machince, recommend that
you start with 8-10cm fresh branches, you can evenly increase diameter as
time goes by.
2. Put the branch on tray and make sure hands out of hopper. Hand off the
branch when you feel the roller starts feeding. For a short twig, you can stop
roller and put the short ahead of the long. then start feeding, push the short
by the long.
3. Refer to the pathway, Feeding and turn.
4. Always pay attention to working status, noise.
5. Confirm the throw direction, No bystanders, No power cable, No animals,
No flammable material, No growing plants.
Notice
13
Summary of Contents for RATEL RC180 D
Page 46: ...45...
