●Choose original blades for replacement
●Keep blades sharp and right angle of anvil
●Keep right gap between blade and anvil
●Fix blade by original bolts, and tighten by right torque. Clean blade and
holder up completely
Overheating of the blade can change the characteristic of the blade edge,
and overheating of the blade can result in small cracks that, if chipping work
continues, it may cause the blade cracking. Overheats when grinding the
blade is strictly prohibited.
The drum must be rotating for several minutes after the engine is switched
off to stop, and do not open the housing cover until the drum has completely
stopped turning, as this may cause serious injury.
Protectives such as goggles and gloves may always be worn when
maintaining chipper, where debris may fly out causing eye injuries, skin
scratches and cuts.
In order to ensure efficient performance, blade should remain sharp all the
time. Time to grind or for replacement, is depending on work condition or
material chipped.
While blade gets blunt, chips quality will get smaller and worse, feeding
speed goes down. Keeping blades sharp, is a must to ensure efficiency of
chipper.
Notice
Danger
33
Summary of Contents for RATEL RC180 D
Page 46: ...45...
