Material preparation
●Inclined head is easier for feeding.
●Make sure material is long enough, over 1.2mm in order to keep hands
away from roller. Short materila can be pushed into roller by long material.
●Necessary adjustment of weight and length of material, by cutting into
piece, could reduce risk on injury to operator.
●This chipper is designed to chip branches with no foreign objects such as
rock, metal, mud and anything could damage machine.
Metal, rock or glass etc. could damage machine seriously, caused loss of
your property or injuries even deaths.
Vine around twigs, could entangle operator, cause damage to machine. so all
vine among your material should be taken away.
Less
than
width
of
hopper
Put small twigs
on top of big
ones
Trim off
branch over
10cm
Length is
over 1.2m
Feed material
with bevel side
up
Start
with this
end
Good preparation of material could raise the efficiency, improve working
condition and reduce risk on possible expense on extra maintenance.
Danger
9
Summary of Contents for RATEL RC180 D
Page 46: ...45...
