Jetter JetMove 225-480, User Manual, Page: 81 / 126

JetMove 225-480 9.1 Error Messages
Jetter AG 81
F 12 Earth fault One or several
phases of the
motor cable or
inside the motor
have been short-
circuited to earth. – Immediate
controller
disable
– Check the motor cable
and the motor
– Acknowledge failure
F 13
(combined
with F 00) Internal
checksum error An internal
checksum error
has occurred. – Immediate
controller
disable
– Switch the 24 V supply
off and on again
– If the error occurs
repeatedly, return the
amplifier for repair
F 14
(combined
with F 00) Internal
communication
error An internal
communication
error has occurred – Immediate
controller
disable
– Switch the 24 V supply
off and on again
– If the error occurs
repeatedly, return the
amplifier for repair
F 15 The hardware
enable is missing The software
enable is given
without a hardware
enable. – Immediate
controller
disable
– Disable the drive by
means of the software
– Acknowledge failure
F16 Power input
overcurrent The current at the
power input is too
high. – Immediate
controller
disable
– Check input voltage
– Reduce mechanical
power of the motor
– Acknowledge failure
F 17 Software limit
switch has been
actuated Actual position is
outside the
programmed range
and a software limit
switch has tripped. – Stop at max.
current (max.
torque)
– Check target position
– Acknowledge failure
– Return the axis to a
position within the
software travel limits
(monitoring of software
limit switches is re-
enabled automatically at
entering this range)
F 18 Hardware limit
switch has been
actuated One hardware limit
switch has tripped. – Stop at max.
current (max.
torque)
– Check target position
– Check reference
position
– Acknowledge failure
– Return the axis to a
position within the
machine travel limits
(monitoring of hardware
limit switches is re-
enabled automatically at
entering this range)
Fault Message Table JetMove 225-480
Fault
Number Type of Error Description Error
Response Rectification