JDS Uniphase SmartClass E1, User Manual

Page: 21 / 144

Chapter 1 Getting Started
Preparation for use
SmartClass E1 Tester User’s Guide 5
To order accessories for your E1 Tester, contact JDSU Customer Care, your
JDSU TAC representative, or your local JDSU sales office. You can also
contact JDSU through the company web site,
www.jdsu.com .
Preparation for use
This section explains how to start using your E1 Tester.
General preparation
When you unpack the E1 Tester, do the following:
– Inspect the tester for damage.
– If undamaged, save the box and packing materials in case you need to
ship the tester in the future.
Before using the E1 Tester for the first time, do the following:
– If you are using alkaline batteries, verify that your unit is OFF, and then
install fresh batteries in the tester.
– If you are using rechargeable batteries, verify that your unit is OFF, and
then install the batteries in the tester. Before testing, make sure the
batteries have been fully charged (see
“Recharging the batteries” on
page 104 ).
– Turn the unit ON (see “Powering ON your unit” on page 10 ).
– When prompted, specify the type of battery you installed.
– Verify that your unit is operating properly by navigating through a few
menus.
CB-0045402 External 2M Reference Clock cable
Datacom testing
CB-44391 X.21 10 MHz DTE/DCE Emulate
CB-44346 X.21 Monitor
CB-44385 V.24 DTE/DCE Emulate
CB-44348 V.24 Monitor
CB-44389 V.35 DTE/DCE Emulate
CB-44341 V.35 Monitor
CB-44388 V.36 DTE/DCE Emulate
CB-44347 V.36 Monitor
CB-21128081 68-pin MDR to DB-15 cable (DTE emulation, for inter-
face to network)
CB-21118474 68-pin MDR to Bananas (for Co-directional, Contra-
directional and Centralized testing)
Table 5 SmartClass E1 Tester optional accessories (Continued)
Catalog Number Accessory