JDS Uniphase SmartClass E1, User Manual

Page: 105 / 144

Chapter 7 Test Results
Jitter results
SmartClass E1 Tester User’s Guide 89
Jitter results
Table 22 lists and describes each of the test results in the Jitter category.
Graphical and Tabular jitter
results
When testing jitter, you can view results in a graphical or tabular format by
selecting the corresponding result categories in the Interface group.
Jitter Graph The jitter graph is available when manually testing jitter, and when measuring
MTJ and Fast MTJ.
MTJ Graph and Table The MTJ graph and table are available when measuring MTJ and Fast MTJ.
JTF Graph The JTF graph is available when measuring JTF.
Signal results
The Signal results report the same results as the other E1 tests. See “Signal
results” on page 79 .
Interface results
The Interface results report the same results as the other E1 tests. See “Inter-
face results” on page 80 .
BERT results
The BERT results report the same results as the other E1 tests. See “BERT
results” on page 81 .
Event Log
The Event Log results report the same results as the other E1 tests. See “Event
Log” on page 89 .
Event Histogram
The Event Histogram results report the same results as the other E1 tests. See
“Event Histogram” on page 94 .
Table 22 Jitter test results
Test Result Description
Rx Jitter (UIpp) The maximum peak-to-peak jitter measured since
starting or restarting the test, expressed in UIpp.
Max Rx Jitter (UIpp) The maximum peak-to-peak jitter measured since
starting or restarting the test, expressed in UIpp.
Rx 18-100 KHz (UIpp) The peak-to-peak jitter outputted from the
18-100 k filter since starting or restarting the test,
expressed in UIpp.
Max Rx 18-100 KHz (UIpp) The maximum peak-to-peak jitter outputted from
the 18-100 k filter since starting or restarting the
test, expressed in UIpp.