JCM GAMMA VERSUS M20, Manual

Page: 38 / 111

GAMMA VERSUS MANUAL
38
COD. 1257066 Gamma VERSUS Manual v1.13
7.9 No stop on opening function
4 - Control panel enters to deadman mode in case of user wants to move the door (by
using an “open” of “close” command) and there is a security activated. It is needed to
press the open or close button (even by using a deadman transmitter) at least the
pressing time defined by the
P4F configuration parameter. Meanwhile the open and
close button is pressed the LED associated to the active security will flash in order to
inform the user.
Notes By security, normal transmitters can’t be used to enter to deadman mode. Only special
deadman transmitters can be used.
In deadman mode securities are not taken into account but stop command and
mechanical limit switches signals have higher priority. Therefore is a stop command or a
mechanical limit switch is detected during deadman mode the movement will stop.
Model All
Associated
parameters
ID Description Type
P03 No stop on opening ON/OFF
Description The no stop on opening function avoids stopping the opening maneuver if an
“alternative” or “close” pushbutton is pressed.
Configuration To enable the no stop on opening function it is needed to set to ON the P03
configuration parameter by means of a VERSUS-PROG programming tool. It is also
possible to enable or disable this function by setting the “No stop on opening ON/OFF”
function to an option switch.
Operating If this function is enabled when an “alternative” of “close” pushbbutton is pressed during
the opening maneuver it is not taken into account.
This function is normally used on neighboring communities to avoid closing the door if a
neighbor is waiting while the door opens and a new neighbor arrives and presses again
the transmitter.
Notes Even no stop on opening function is enabled, “stop” commands or security commands
are taken into account to ensure user security.