JCM GAMMA VERSUS M20, Manual

Page: 13 / 111

GAMMA VERSUS MANUAL
13
COD. 1257066 Gamma VERSUS Manual v1.13
1 – ON
memorized a mechanical stop on closure and, therefore, will act
accordingly. In most cases, it will close until the mechanical stop is
found.
21
HALLB IN available 0 – OFF Enables the second Hall input (HALL_B).
1 – ON
22
Lock mode
0 – OFF Indicates the RSENS lock configuration, if it has been detected on
programming mode.
1 – ON
23 RBAND detected
0 – OFF Indicates the RBAND presence, if it has been detected on
programming mode.
1 – ON
24
Error info displayed 0 – OFF Enables the advanced level of errors/warnings displayed.
1 – ON
25
Pedestrian mode 0 – OFF Enables the pedestrian mode.
1 – ON
26
Motor outputs inverted 0 – OFF Enables the sense inversion of motor outputs.
1 – ON
27
Maximum speed close 0 – OFF Enables the closing action at maximum speed.
1 – ON
28
RBAND mode 0 – OFF Enables the RBAND mode.
1 – ON
29
RSENS mode 0 – OFF Enables the RSENS mode.
1 – ON
2A
RSENS detected 0 – OFF Indicates the RSENS presence, if it has been detected on
programming mode. 1 – ON
2B
Time/HALL autoconfig
0 – OFF Enables the automatic detection of time mode or Hall mode.
1 – ON
2C
Half Dead man mode 0 – OFF Enables the semi-deadman mode.
1 – ON
2E
Deadman if RSEC virgin 0 – OFF Enables dead man operating if a not programmed RSEC/R is
detected. 1 – ON
2F Autodetect OptoEdge IN1 0 – OFF Indicates that the IN1 input is configured as optical edge input.
1 – ON
30 Autodetect OptoEdge IN2 0 – OFF Indicates that the IN2 input is configured as optical edge input.
1 – ON
31
Autodetect OptoEdge IN3 0 – OFF Indicates that the IN3 input is configured as optical edge input.
1 – ON
91
Pre-FLASH option
0 – OFF Enables the pre-flash function at the beginning of the manoeuvre.
1 – ON
92 RSENS Dynamic Radio 0 – OFF Enables the dynamic adjustment mode the radio power for the
RSENS.
1 – ON
B1
Block On/off by password
0 – OFF Enables the blockage of the control panel via password (default
value 0000).
1 – ON
B4 Current blockage status
0 – OFF Indicates if the control panel is blocked currently.
1 – ON
B6
Recharge maneuver
0 – OFF Enables the activation of the recharge maneuver during 3 seconds
each hour.
1 – ON
BD
Reverse strike at open 0 – OFF Enables the reverse strike at open
1 – ON
BE
Absolut encoder mode 0 – OFF Enables the operating by absolute encoder, that means that the
position control is done by the absolute encoder control 1 – ON
C1
Commercial mode 0 – OFF
1 - ON Enable commercial mode, that means that the opening is done in
deadman or automatic mode and the closing always in deadman
mode.
C2
Programming forced 0 – OFF
1 - ON Enable the programming sequence forced, that means that once the
control panel is power supplied, it enters automatically in
programming mode.
C3
Step by step sequence 0 – OFF
1 - ON Enable step by step sequence operating through start button.