JCM GAMMA VERSUS M20, Manual

Page: 16 / 111

GAMMA VERSUS MANUAL
16
COD. 1257066 Gamma VERSUS Manual v1.13
normally be the current limit that the panel will accept during operations at
slow speed.
45
Current margin 10 Level of sensitivity with which an obstacle due to overcurrent will be
detected during normal operations. In other words, the value that is added
to the memorised current curve and that stipulates the current limit
permitted at each movement point (motor power).
46
Norm/Low speed
factor 10 Ratio between the normal and slow speed of the door. The higher the
value, the lower speed.
47
Max.security
detections 10 Number of security trigger reversals permitted before auto-close is
inhibited. Where the door exceeds this maximum number of consecutive
closure reversals without being able to close completely, the auto-close
function will be disabled.
48
Max.autotests
before err. 10 Number of autotest repeats allowed before going out and showing error.
49
Time to close by
SEC.CL 1000 Waiting time before doing the closing movement by security contact.
4A Electrolock time 10 Activation time of the electrolock.
4B
Courtesy light time 10 Activation time of the garage light.
4C
Flash frequency 10 Flash period time.
4D Pre-flash time 10 Pre-flash time.
4E
Max.sequence
time 10 Maximum maneuver time.
4F
Press.time to
deadman 10 Needed pushing time of the Open or Close Pushbutton to enter to
deadman mode.
50 Panic signal period 10 Activation time of the panic signal.
51
Integrator value
TH1 1000 Integrator threshold 1 value (internal limit switch detection).
52
Integrator value
TH2 1000 Integrator threshold 2 value (internal limit switch detection).
53
RSENS
inhib.margin 10 Inhibition zone of the closing maneuver of RSENS.
93
Current margin in
PROG 10 Level of sensitivity with which an obstacle due to overcurrent will be
detected during programming.
94
AC Motor speed
regul. 10 AC motor power regulation value.
95
AC Motor LOW sp.
Regul. 10 AC motor power regulation value in slow speed.
B2
Password value 100(*) Password's value for the blockage of the control panel.
B3
Inversion time by
SEC.CL 100 Inversion time after closing security detection.
B5
Traffic control
mode 10 Indicates the value of the traffic control mode.
C0
Maintenance
counter 100000000 Maintenance counter. It increases in each full maneuver (o
closing).
C7
Partial opening
time per inversion
on closing. 1000 Time of partial opening per inversion on closing.