JCM GAMMA VERSUS M20, Manual

Page: 101 / 111

GAMMA VERSUS MANUAL
101
COD. 1257066 Gamma VERSUS Manual v1.13
Replacing a transmitter
If a transmitter becomes damaged the whole system must be reset and replaced, and non-damaged transmitters
must then be re-programmed into the receiver.
Use of the system
The system is designed to be installed as specified in the introduction. Other applications than specified are not
guaranteed.
Manufacturer reserves the right to change the equipment specification without prior warning
Important annex
Disconnect power supply whenever you proceed any installation or repair of the control panel.
In accordance with the European low voltage directive, the following requirements are informed:
· For permanently connected equipments, an easy-access connection device must be provided.
· This system must only be installed by qualified persons with experience in automatic doors/gates installations and with
knowledge of the applicable EU standards.
· The instructions for use of this equipment must always remain in the possession of the user.
· System’s work frequency does not interfere with the 868 MHz remote control systems.
JCM TECHNOLOGIES, S.A.
declares herewith that the product RSEC3 complies with the relevant fundamental
requirements as per Article 3 of the R&TTE Directive 1999/5/EG, and complies with the relevant fundamental
requirements of the 2006/42/CE Machinery Directive, as well as with the ones of the 2004/108/CE Electromagnetic
Compatibility Directive and 2006/95/CE Low Voltage Directive, insofar as the product is used correctly.
EC Declaration of conformity
See website www.jcm-tech.com