JCM GAMMA VERSUS M20, Manual

Page: 37 / 111

GAMMA VERSUS MANUAL
37
COD. 1257066 Gamma VERSUS Manual v1.13
7.8 Deadman function
Model
All
Associated
parameters
ID Description Type
P07 Deadman ON/OFF
P4F Press.time to deadman NUMERIC
P5E...P77 IN XX INPUT
Description The deadman function allows moving the door even securities are activated.
Configuration To enable the deadman function it is needed to set to ON the P07 configuration
parameter by means of a VERSUS-PROG programming tool. It is also possible to
enable or disable this function by setting the “Deadman ON/OFF” function to an option
switch.
The P4F configuration parameter allows modifying the button pressing time (button or
deadman transmitter) needed to enter to deadman mode if a security is active.
P5E to P77 parameters allow assigning an input value to every available control panel
input. “Open deadman” and “Close deadman” input values can be assigned to these
inputs. By using these inputs control panel enters directly to deadman mode.
Operating There are four ways to enter to the deadman mode:
1 - Deadman mode enabled by P07 configuration parameter. Every “open” and “close”
command (even by control panel button or deadman transmitter) will move the door in
deadman without taking into account the security inputs status.
2 - It is possible to enter to deadman mode, in programming state, by pressing the open
and close buttons in order to fix the door position before starting the programming
sequence.
3 – Control panel enters to deadman mode if there is any input configured as “Open
deadman” or “Close deadman” type and it is activated.