![background image](http://html1.mh-extra.com/html/jcm-global/uba-rc-series/uba-rc-series_operation-and-maintenance-manual_3545425025.webp)
P/N 960-100928R_Rev. 3 {EDP #192692}
© 2018, JAPAN CASH MACHINE CO., LTD.
2 - 1
S e c t i o n 2
This section provides installation and operating
instructions for the UBA-RC
™
Series Banknote
Recycler Unit (UBA-10/12-SH2/SS-RC; UBA-
RC
™
). The information within contains the
following features:
•
Installation Procedure
•
Cable Interconnection
•
DIP Switch Configuration
•
Jumper Configurations
•
Connector Pin Assignments
•
Preventive Maintenance
•
Clearing a Banknote Jam
•
Cleaning Procedure
•
Standard Interface Circuit Schematics
•
Operational Flowcharts
Installation Procedure
Holes are provided in each Frame Unit to accom-
modate mounting the UBA-RC
™
during installa-
tion. Select and perform the following steps
required to install the UBA-RC
™
Unit:
1. When a side mounting configuration is preferred,
bolt the left or right side of the UBA-RC
™
Frame
into its intended location using six (6) M4 Screws
from either side of the Frame (Figure 2-1).
2. When a rear mounting configuration is preferred,
bolt the inside back of the UBA-RC
™
Frame into
its intended location using four (4) M4 Phillips
a
1
through
a
4
).
3. When a bottom mounting configuration is pre-
ferred, bolt the inside or outside of the UBA-RC
™
Frame into its intended location using four (4) M4
Phillips Head Screws. To bolt the Frame down
from the inside, place the screws in the four un-
threaded holes located inside the Frame (Figure
b
1
to
b
4
); or bolt the Frame down from the
outside using the four (4) threaded Stud Insert
holes located on the outside of the Frame (Figure
c
1
to
c
4
).
2 INSTALLATION
M4 Screws Locations (Right/Left)
Figure 2-1
M4 Screws Locations (Right/Left)
Figure 2-2
Figure 2-2
M4 Screws Locations (Rear & Bottom)
a
1
a
3
a
2
a
4
b
1
b
3
b
2
b
4
c
3
c
2
c
4
c
1
NOTE: Choose two (2) of the five (5)
installation configuration sides shown, and
bolt the correct number of M4 Screws firmly
in place. When bolting the Screws from the
outside, the maximum length of each M4
Screw must be less than 7mm long.