![background image](http://html1.mh-extra.com/html/jcm-global/uba-rc-series/uba-rc-series_operation-and-maintenance-manual_3545425046.webp)
P/N 960-100928R_Rev. 3 {EDP #192692}
© 2018, JAPAN CASH MACHINE CO., LTD.
4 - 2
Section 4
UBA-RC® Series Banknote Recycler
Disassembly/Reassembly
Recycler CPU Board
Assy Removal
To remove the Recycler CPU Circuit Board Assem-
bly, proceed as follows:
1. Unplug the twelve (12) Connectors (Figure 4-3
a
)
from the Recycler CPU Circuit Board Assembly
b
), and remove the three (3) Har-
nesses from their three (3) related Retainer
Clamps (Figure 4-3
c
1
,
c
2
&
c
3
).
2. Remove the two (2) Mounting Screws (Figure 4-4
a
1
&
a
2
) retaining the bottom of the RC Bezel
Assembly (Figure 4-4
b
) in place, and lift the RC
Bezel Assembly off of the Frame.
3. Remove the four (4) Mounting Screws (Figure 4-
c
1
to
c
4
) retaining the Recycler CPU Circuit
Board Assembly in place (Figure 4-4
d
) and take
the Recycler CPU Circuit Board Assembly off of
the Frame.
Emission Side Double Note
Sensor Removal
To remove the Emission Side Double Note Sensor,
proceed as follows:
1. Remove the Frame Transport Guide (Figure 4-5
a
) from the top of the Frame.
2. Remove the Emission Side Double Note Sensor
c
) from the Frame Transport Guide,
and unplug its single (1) Signal Connector (Fig-
d
).
Figure 4-2
Lifter Motor Encoder Circuit Board
a
1
a
2
a
3
a
4
c
d e
Figure 4-2
Lifter Motor Encoder Circuit Board
Assembly Removal
Figure 4-3
a
c
1
c
2
c
3
b
Figure 4-3
Connector & Harness Removals
Figure 4-4
a
1
a
2
b
c
1
c
3
c
4
d
Figure 4-4
Recycler CPU Circuit Board Removal
NOTE: When re-assembling the
Frame Transport Guide onto the
Frame, be sure to align the thick part
of the Frame Transport Guide to the
cut out area in the Frame (Figure 4-5
b
).
NOTE: If the Sensor Assembly does
not remove easily, place the small
head of a Flat-blade Screwdriver
into the hole located on the back
side of the Frame Transport Guide,
and gently push the Sensor out of
the Frame (Figure 4-5
e
).