![background image](http://html1.mh-extra.com/html/jcm-global/uba-rc-series/uba-rc-series_operation-and-maintenance-manual_3545425026.webp)
P/N 960-100928R_Rev. 3 {EDP #192692}
© 2018, JAPAN CASH MACHINE CO., LTD.
2 - 2
Section 2
UBA-RC™ Series Banknote Recycler
Installation
Cable Interconnection
Figure 2-3 illustrates the Cable interconnection
requirements between the UBA-RC
™
and a Host
Machine.
DIP Switch Configuration
This section provides the denomination DIP Switch
Block settings for the UBA-RC
™
Unit.
Jumper Configurations
The UBA CPU Circuit Board contains three (3)
Jumper Plugs that are located adjacent to one
another. Photo-coupler Isolation and/or RS232C
Protocol selection is configured by these Jumpers.
However, all three (3) Jumper Plugs must set to
identical positions when changed to represent the
configuration desired (Figure 2-4).
Table 2-1
UBA Transport Unit DIP Switch Settings
UBA Transport Unit DIP Switches
Switch
No.
Switch ON
Switch OFF
1
VEND 1 INHIBIT
VEND 1 ACCEPT
2
VEND 2 INHIBIT
VEND 2 ACCEPT
3
VEND 3 INHIBIT
VEND 3 ACCEPT
4
VEND 4 INHIBIT
VEND 4 ACCEPT
5
VEND 5 INHIBIT
VEND 5 ACCEPT
6
VEND 6 INHIBIT
VEND 6 ACCEPT
7
VEND 7 INHIBIT
VEND 7 ACCEPT
8
OFF
OFF
Figure 2-3
Cable Interconnection
a
c
a) UBA-RC Unit
b) Interface Connector
c) Interconnecting Harness
d) Host Machine (Game Machine, Kiosk, etc.)
e) Power Connection Harness
e
d
Table 2-2
UBA-RC Unit DIP Switch Settings
*
UBA-RC Unit DIP Switches
Switch
No.
Switch ON
Switch OFF
1
Reserved
Reserved
2
Reserved
Reserved
3
Reserved
Reserved
4
Reserved
Reserved
5
Reserved
Reserved
6
Reserved
Reserved
7
Reserved
Reserved
8
Reserved
Reserved
*. Refer to each Country’s “Software Information Sheet” for making the
proper Switch settings.
Figure 2-4
3 Jumpers
= Shorted
Photo-Coupler
Isolation
RS232C
Figure 2-4
UBA CPU Circuit Board Bottom View