Iwatsu ENTERPRISE-CS, Owner'S Manual

Page: 97 / 274

IWATSU ENTERPRISE-CS SYSTEM FEATURES - 79
busy, the caller may hear a recorded message when your system is equipped
with an IX-MSGU card or automated attendant. Calls to the UCD group may
search for an idle extension in either a Terminal or Distributed Hunting
pattern. In Terminal Hunting the incoming calls always start hunting from the
first telephone in the group. In Distributed Hunting the incoming calls start
hunting from the telephone following the last called telephone. In both cases,
calls will hunt to the next telephone if a telephone does not answer in a
predefined period of time, is busy, or in the Call Forward or Do Not Disturb
mode. The Iwatsu Enterprise-CS also has the ability to send unanswered calls
to an overflow or secondary answering position after a predefined period of
time. This second answering position may be another UCD group, hunt group,
voice mailbox, extension, or attendant. Additionally, the ECS can be
programmed to disconnect the call when the UCD overflow timer expires.
User Options (Station Programming)
The user programming options listed below are accessible from the 5930,
5910, and 5810 setup menu. Access to these options requires the entry of the
station password programmed in the ECS database.
Station User ID – Change the station ID. Up to eight characters supported.
Station Password – Change the station password. Up to four digits.
Dial Confirmation Tone – Turn dial confirmation tone on or off.
Handset Volume Control – Program the default volume setting that the KT
will always return to after use. Options are Use Last, Low, Medium, and
High.
Hold Recall Timer – Change the value of the Hold Recall Timer between 0
(off) and 255 seconds.
Camp-On Recall Timer – Change the value of the Camp-On Recall Timer
between 0 (off) and 255 seconds.
Station Ring Tone – Choose one of eight tones as the default station ring
tone.
Key Assignment – Change the value of a Self-Labeling key or multi-
purpose key.
Note: The User Key Assignment database setting must be set to Allow
(default = Deny) to allow station users to change Key Assignments.
LCD Backlight Duration – Change the amount of time the LCD backlight
will remain illuminated to a time between 30 seconds (default) and 120
minutes.