ITW Dynatec DY 2008, Operating Manual

Page: 66 / 98

C 1:
C 2:
C 3:
C 4:
C 5:
C 6:
C 7:
C 8:
PATTERN PRESSURE SYSTEM COMP.
1: 0 m/min
PRESS1: 0%
PRESS2: 0% PRESS3: 0%
PRESS4: 0%
PROGRAM.: 1
2: 0 m/min
3: 0 m/min
4: 0 m/min
SYSTEM
RETURN STITCH OFFSET
1: 0 m/min
2: 0 m/min
3: 0 m/min
4: 0 m/min
C 1:
C 2:
C 3:
C 4:
C 5:
C 6:
C 7:
C 8:
SYSTEM MENU
DOTS
DOTS
Page 4-- 48
Manual #50-14 Revised 8/08
C. 1998
System Menus: Dot Configuration, Stitching and Head Position
The shown display appears a few seconds after
switching on the pattern controller. If you are in a
different menu, press F4 RETURN as many times as
necessary to return to the Main Menu, as shown at
right.
Press button F3.
Use this menu to adjust the Dot-Configuration,
Stitching and Head Position (Offset) parameters.
Dot Configuration
The ability to enter the Dot Configuration Menu is
offered when one of the “dot modes” (i.e. STANDARD
WITH DOT or DOT) have been selected in the Service
Settings Menu 1 of 3, Function 8.
Press button F1 from the SYSTEM MENU.
Only
those channels with modes
programmed for dots (see above) will be
displayed.
Use the F1 or F2 buttons to select a channel.
Press the F3 button to highlight the REPEAT
value. The REPEAT is the distance in
millimeters (inches) that the product must
travel before the next dot will be applied.
CHAN. 3
1: 0 m/min STOP
ZURUECK
DOT CONFIGURATION REPEAT (mm) GLUE (ms)
RETURN
1
10
1.00
4.50
CHAN. 2
CHAN. 2
CHAN. 3
1: 0 m/min STOP
ZURUECK
DOT CONFIGURATION REPEAT (mm) GLUE (ms)
RETURN
1
10
1.00
4.50
5
+ 1 mm - 1 mm
123