ITW Dynatec DY 2008, Operating Manual

Page: 32 / 98

RETURN
ACCESS CODE: ----
STOP 1: 0 m/min
123
TIME
CO
CONTRAST- RETURN
LANGUAGE
LOAD PROGRAM
CHANNEL : TRIGGER
TRIGGER LOCK
CHANNEL : ENCODER
ENCODER SCALING
MIN/MAX SPEED SET.
CHANNEL MODE
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
--
STOP 1: 0 m/min
SERVICE SETTINGS 1 OF 3
123
RETURN
Page 4-- 14
Manual #50-14 Revised 8/08
C. 1998
Select Channel/Trigger Assignment
Use this menu to determine which trigger should be assigned for the selected channel
or to deactivate this channel. It is also possible to combine with an additional trigger via
AND--function. In this case that channel will be triggered only when both trigger inputs
are active.
NOTE! Master triggers 1 thru 4 (X9 thru X12) may be assigned to any channel.
Dedicated channel triggers are also available for each channel, #5 and greater.
Press Button 3.
Enter Access Code if this function is
protected.
Press Enter Button.
Select a channel with buttons F1 and F2.
With Button F3 you can select a trigger
(Master Triggers 1 to 4 or Channel Trigger
for channels 5 and greater) for the selected
channel or you can deactivate this channel.
Press F1 if you want to combine this
trigger with another trigger using the
’AND’--function.
NOTE! Select “AND”
trigger value prior to “TRIGGER” value for
programming ease.
Use buttons F2 and F3 to select a trigger for
the ’AND’--function or to switch Off the
’AND’--function.
NOTE! Only Master
Triggers 1 thru 4 are available as “AND”
triggers.
Press Enter button to accept the “AND”
trigger assignment. Press the Enter button
again
to accept the basic trigger
assignment.
Repeat the procedure for the next channel.
Press button F4 to return to previous menu.
Channel
1
2
3
4
STOP 1: 0 m/min
TRIGGER
In1
CHAN.OFF
In1
In1
AND-TRIGGER
AND-OFF
AND-OFF
AND-OFF
AND-OFF
AND
ZURUECK
CHANNEL : TRIGGER ASSIGNMENT MENU
RETURN