IEEE-488 Commands
Copyright © Itech Electronic Co., Ltd.
75
Chapter16 IEEE-488 Commands
This chapter introduced often-used IEEE-488 commands.
*CLS
This command is used to clear following registers:
⚫
Standard Event Register
⚫
Query Event Register
⚫
Status Byte Register
Command Syntax
*CLS
Parameters
None
*ESE
This command is used to edit the value of standard event enable register.It
defines the specified bits from standard event register that will cause the value
of ESB bit in status byte register to be 1.
Command Syntax
*ESE <NR1>
Parameters
0
～
255
Power-On Value
Refer to *PSC command
Example
*ESE 128
Query Syntax
*ESE?
Returned value
<NR1>
Relevant Command
*ESR? *PSC *STB?
*ESR?
This command is used to read the value of standard event registers.And values
will be cleared to zero after executing this command.The bit definiation of
