Isotra HRS-ZIP, Technical Manual

Page: 98 / 154

SCREEN BLINDS
98
Bottom rail (6-015158-0000)
The bottom rail consists of a two-piece, left and right sliding block and an extruded aluminium profile with
a powder-coated finish.
The profile has:
•
A groove for screw-free attachment of the fabric using a canvas rod of Ø 3 mm
•
A chamber for a strengthening strip
•
A slot at the bottom to insert a rubber stopper (there is also the option to select a brush strip)
The two-piece sliding block ensures the fabric is correctly tightened.
Fabric roll
Depending on the width and the type of fabric, either the Ø 55 mm extruded aluminium roll or the Ø 78 mm roll made of
galvanised steel (see table).
The fabric rolls have a groove for attaching the fabric, using a canvas rod of Ø 4 mm for the Ø 55 mm roll and a canvas rod
of Ø 6 mm for the Ø 78 mm roll.
The fabric rolls have a groove for attaching the fabric, using a canvas rod of Ø 4 mm for the Ø 55 mm roll and a canvas rod
of Ø 6 mm for the Ø 78 mm roll.
Fabric roll Ø55 mm* Ø78 mm
6-014027-0000 6-015160-0000
Material aluminium galvanized steel
Rod Ø4 mm Ø6 mm grooved
Total width of screen
Soltis 92
645–815 mm 815–4500 mm
Satiné 645–815 mm 815–4500 mm
Blackout
645–815 mm 815–4500 mm
*As standard there is delivered the motor LS40 or Sunea 40 io. For RTS control it is necessary to order lS40 motor with
shutter in the wall.
Side caps (6-015130-0000, 6-015131-0000)
The side caps consist of two separate parts:
•
A fixed side console (left, right)
•
An insert module (left, right)
Side cap left/right (6-015130-0000/6-015131-0000)
Dimension: 122 x 140 mm
The aluminium side consoles have an integral pivot that fits in the base section of the
guide rail. On the inside there are vertical ridges, one of which the bottom lath fits into
and one for sliding the insert module into. The insert module can click securely into the
lip.
Insert module for side cap left/right (6-015161-9004/6-015162-9004)
Dimension: 66,5 x 115 mm
The insert modules are made of polyamide reinforced with glass fibre. They have a
number of holes for securing the motor on the motor side, or a hole for a fabric roll on
the opposite side. The corresponding holes must be used for each fabric
roll diameter. By pressing the click stub inwards, the insert module is released from the
side console.
There are two holes in the bottom to secure the base plate toucher to the side consoles.
AS 67
AS 78
AS 55
AS 67
AS 78
AS 55