Isotra HRS-ZIP, Technical Manual

Page: 87 / 154

SCREEN BLINDS
87
Based on the installation situation, there are several ways the screen can be installed:
Method 1. Affix the box using the mounting brackets, then slide the guide rails onto the console pivot and secure the gui-
de rails with screws.
Method 2. Place the complete box / guide rail assembly in or against the window opening and screw them in place.
Method 3. Screw the guide rails in place. Then push the box onto the guide rails and secure it in place.
Box type X
70 37
90 53
110 73
150 114
spirit level
Place the mounting brackets against the
mounting surface. Use the upper holes for
mounting against a ceiling and the rear
holes for mounting against a wall.
The box must be perfectly level, so make
sure the brackets are aligned properly. Use
a hose level and a plumb line or another
suitable tool for this task.
max. 1500
x
Step 2: Installing the box on the mounting brackets
One mounting bracket per console, as close as possible
to the console.
Any additional brackets are mounted in the middle of the
box, evenly spaced across its width, and are intended to
prevent wider boxes from sagging.
(1) Push the box upwards into the mounting brackets.
(2) Feed the motor cable through to the inside. Then
push the box into the brackets so the slots in the back
of the box engage with the L-profilings.
(3) Next tighten the Allen screws of each bracket. The
screws should grip in the slots at the top of the front
of the box.
z = 40 - 100
30
z
METHOD 1
Affix the box using the mounting brackets, then slide the guide rails onto the console pivot and secure the guide
rails with screws
Step 1: Drilling holes for the mounting brackets
SCREEN HR7 and HR8-ZIP
Assembly