Iseki TJ75, Operation Manual

Page: 27 / 117

TJ75
26
Coolant Temperature Gauge
FIG. 4-6: Gauge, 4, indicates engine coolant
temperature when main switch is selected to ON
・ - Shows too cool temperature for severe work.
Allow to warm before applying heavy load.
・ - Indicates overheating. Reduce engine speed to
idle, allow to run at no load several minutes and
investigate cause (refer to Troubleshooting).
CAUTION: Do not service hot engine. Allow
to completely cool before servicing or
removing radiator cap.
Tachometer
FIG.4-7 & 4-8: Scale,5, indicates engine speed in crank
shaft revolutions per minute(rpm). Digital panel indicates
not only engine revolutions but also traveling speed, rear
PTO speed, mid PTO speed, hourmeter, trip meter.
Indication of degital panel is changed by pushing the
selectable switch,6.
When rear PTO speed is 540, engine revolutions is
approximately 2430 rpm.
Normally, the PTO speed should be between 540 and
Operating the PTO at a speed above 600 is too fast, and
may result in breakdown of the tractor or implement.
The engine hourmeter is used to assist in maintenance
intervals of the tractor in 1 hour increments.
The tripmeter is used to assist in operation. The extreme
right digit indicates 1/10 hour increments. To reset the
tripmeter, push the selectable switch for two seconds.
FIG. 4-6
4
FIG. 4-7
5
FIG. 4-8
6