Iseki TJ75, Operation Manual

Page: 109 / 117

TJ75
108
ASSEMBLY & PRE-DELIVERY INSPECTION
1. Remove wheels, fenders, and sundry boxes from
container.
2. Disassemble container.
3. Inspect Tractor for damage and any evidence of
coolant, fuel or lubricant leaks.
4. Inspect and remove all hardware securing Tractor to
lower crate panel.
5. Left Fender:
a. Remove tie strap holding control levers.
b. Install and secure fender to floor pan and rear
upright supports.
c. Secure PTO lever bracket and transmission
control lever guide (quadrant) to inside fender
surface. Install with three bolts with lock washers
and flat washers. Install one extra washer on
each of the rear inside bolts.
d. Install knobs on control lever(s).
6. Right Fender:
a. Remove tie strap holding control lever(s) for
shipping.
b. Install and secure fender to floor pan and rear
upright.
c. Secure hydraulic control lever guide, (quadrant)
to inside fender surface. Install using three bolts
with lock washers and flat washers. Install one
extra washer on each of the rear inside bolts.
d. Install knobs on control lever(s).
ASSEMBLY
IMPORTANT: Do not commence assembly of this
Tractor until reading these instructions
completely and carefully.
NOTE: For certain lubrication, adjustments, etc., refer
to appropriate section of this booklet. All nuts,
bolts, etc., on these Tractors are METRIC
dimensions.
Tractor is shipped in individual container. The Tractor will
be partially disassembled to make container as compact
as possible. Wheels, fenders, lift linkage, drawbar, and
some attaching hardware will be removed.
Larger items will be fastened in container and remainder
of items will be shipped in sundry boxes also in
container.
Certain areas of Tractor may be covered with thin film of
protective wax. It may be removed by steam cleaner and
detergent solution during assembly.
Tractor will arrive with battery installed.
To assemble and pre-deliver the Tractor, proceed as
follows:
CAUTION: Be observant of components
(wheels, fenders, etc.) that may be attached
to, or held in position by container panels.