Iseki TJ75, Operation Manual

Page: 111 / 117

TJ75
110
PRE-DELIVERY INSPECTION
- Check that engine oil level is correct.
- Check that coolant level is correct.
- Check fan belt tension, 10mm deflection, when
subjected to a force of thumb pressure.(5kgf)
- Check that transmission oil level is correct.
- Install a sufficient amount of No.2 diesel fuel to
complete pre-delivery service.
- Ensure clean and tight cable connections at battery.
Battery must be securely mounted.
- Check air cleaner, element, hoses, and clamps for
correct installation.
- Check brake pedal linkage for correct free-travel.
- Check steering and brake linkage cotter pins and lock
nuts for secure installation.
- Check filter element and, all connections and clamps
for hydraulic pump and filter.
- Check oil level in front drive axle. Place fuel filter
shutoff valve in the ON position. Take up position in
operator's seat and engage parking brake.
- Place all shift levers in neutral.
- Place rear PTO selector lever in neutral.
NOTE: Engine will not start unless range shift lever is
selected to neutral, rear PTO, selector lever are
in neutral.
- Set throttle lever at half to full throttle and turn main
switch counterclockwise 5-10.
- Turn main switch clockwise to ON. Oil pressure and
alternator warning lights will illuminate. Hold in ON
position 1-2 seconds.
- Turn main switch to START to crank the engine.
Release key to ON position the moment engine
starts. Check that warning lights go out.
- Allow engine to warm up to operating temperature at
about 1500 rpm.
- Operate Tractor to confirm it operates smoothly at all
speeds including four-wheel drive (if so equipped).
- Operate PTO to see that it functions properly.
- Check that all lights and instruments operate properly.
- Check brakes for balanced operation.
- Check warm engine low idle speed, 950-1000 rpm.
- Check warm engine high idle speed, 2800-2900 rpm.
- Set throttle lever at idle, shut off engine and check
Tractor for coolant, lubricating oil or fuel leaks.
- Check that safety start system functions correctly.
- Lubricate all fittings.
- Check tire inflation pressures.
- Check front wheel toe-in.
- Test anti-freeze to see that it is adequate for local
climate condition.
NOTE: Factory fill is set to 30F (-34 cent-degrees).
- Check to see that all safety decals and safety switches
are in place.
- Clean and polish sheet metal as necessary.
- Fill fuel tank to prevent moisture accumulation.
- Review this Operator's Manual with the customer
when delivering or demonstrating Tractor.