Iseki TJ75, Operation Manual

Page: 110 / 117

ASSEMBLY & PRE-DELIVERY INSPECTIION
109
7. Front Bumper - Install front bumper and secure with
four bolts supplied in sundry box.
8. Rear Lights - Install red lights at rear of fenders. The
hardware and wiring retainer straps are installed on
the light for shipment.
After attaching light, attach electrical connectors to
connectors located at fender and ROPS support.
Green wire with white stripe will attach to red wire with
black stripe. Black ground wire will attach to orange wire
with black stripe.
9. Warning Flashers - Install amber turn / warning lights
to fenders as follows:
a. Remove nut, internal lock washer and ground
wire from light.
b. Insert bolt with center wire down through hole in
ROPS bracket and reinstall ground wire, internal
lock washer and nut. Tighten nut.
c. There are three wires, with single connectors,
coming out at top rear of ROPS, support. Two
wires are the same length. They attach to wires
from warning / flasher light. Male and female
couplers prevent improper installation.
d. The remaining connector is used if a work light or
radio is installed.
10.Seat - Remove bolts from seat frame and install seat
using same hardware.
11.Three-Point Hitch - Three-point hitch is partially
assembled, with lift links attached at the top to the lift
shaft, and away chains attached to the lower links.
a. Attach lower links to Tractor attaching points
and secure with lynch pins. Lower links will flare
out ward t rear and retaining rings for spring will
locate at underside.
b. Connect clevis end of check chains to axle brack-
ets and secure with clevis pin and cotter pin.
c. Remove bolts at lower end of lift links and attach
lift links to identical positions on lower links using
bolts, lock washers and nuts removed. Lift link
with turnbuckle adjustment is located on right
side.
IMPORTANT: Bolts should be installed with heads
to out-side (nuts on inside) of lift link,
to prevent tire interference during
operation.
d. Connect top link to anchor point on Tractor using
19 mm x 220 mm pin and lynch pin. Lock nut on
top link barrel will locate to rear. Store top link
implement pin (19 mm x 86 mm) and clip in rear
end of top link.
e. Connect spring to retaining rings at underside of
lower links.
12.Drawbar - Install drawbar fully into bracket at rear of
Tractor and secure with pin and clip provided.
13.Front Wheels -
a. Carefully raise and block front of Tractor.
b. Install wheel / tire assemblies and secure using
bolts and lock washers. Tighten to 75 ft-lbs. (102
Nm).
c. Remove blocking and lower front of Tractor.
14.Rear Wheels -
a. Carefully raise and block rear of Tractor at each
side to prevent pivoting of front axle.
b. Install wheel / tire assemblies and secure using
lock washers and bolts. Tighten to 80 ft-lbs. (120
Nm).
15.Steering Wheel - After wheels have been installed,
place front wheels in a straight forward position.
a. Remove cotter pin, nut and flat washer from
steer-ing wheel shaft.
b. Use a screw driver or flat blade to pry between
steering wheel and cap to remove cap.
IMPORTANT: Don't use a punch through hole in
steering wheel to remove cap. It will
separate the emblem from cap.