Iseki TJ75, Operation Manual

Page: 77 / 117

TJ75
76
LUBRICATION DETAILS
Grease Fittings
Lubricate all grease fittings every 50 hours of operation.
Clean grease gun and fittings before and after greasing
to prevent contamination from dirt.
NOTE: When operating in muddy or extremely wet
conditions, daily lubrication of fittings is
recommended.
Engine Oil & Filter
Engine oil and filter should be changed after first 50
hours of operation and then every 100 hours thereafter.
FIG. 6-4, 5: To Check Engine Oil Level - Tractor must
be parked on level ground with engine off. Pull out
dipstick, 1, and check that oil level is between upper
limit, and lower limit, on dipstick. Wipe off dipstick,
momentarily reinstall in engine and check oil level again.
Add oil through filler opening, 2, as required.
NOTE: Add oil slowly to assist in venting air from
crankcase.
FIG. 6-6: To Change Engine Oil - Operate Tractor until
oil is adequately warmed. Remove drain plugs, 3, from
engine and allow all oil to drain.
Reinstall drain plugs and fill engine crankcase to upper
limit on dipstick.
FIG. 6-4
←Upper limit
←Lower limit
1
FIG. 6-5
2
FIG. 6-6
1