3
Tractor operation
54
Drawbar
position
Distance of
clevis from
end of PTO
shaft ‘X’
Maximum
static
loadings
Inner
position
241 mm
(9.5 in)
1000 kgf
(2205 lbf)
Centre
position
355 mm
(14 in)
775 kgf
(1710 lbf)
Outer
position
400 mm
(16 in)
775 kgf
(1710 lbf)
Table 2
Drawbar length (Fig. 32)
Fig. 32:
4
2
1
3
5
To adjust the drawbar height proceed
as follows:
1. Remove the bolt and keep plate (1).
2. Remove the drawbar pin (3).
3. Reposition the drawbar using one of
the three holes (5), see Table 2 .
Refit the pin (3), keep plate and bolt (1).
Drawbar height (Fig .33)
To adjust the drawbar for length pro-
ceed as follows:
1. Remove the drawbar pivot pin as de-
scribed in ‘Drawbar length’.
2. Remove the clevis and reposition in
one of the positions shown in Fig. 32,
the dimensions from the centre of
the PTO shaft are given in Table 3 on
the next page. Tighten the bolts to a
torque of 230 Nm (170 lbf ft).
Position
Height
A
165 mm (6.25 in)
B
265 mm (10.13 in)
C
65 mm (4.25 in)
D
165 mm (8.13 in)
Table 3
3. Refit the drawbar.
Fig. 33: Adjustment of drawbar.
Drawbar lateral adjustment (Fig. 34
and Fig. 35)
The drawbar may be fixed in any one of
five positions or allowed to swing the full
width of the frame. The maximum lateral
swing is 240 mm (9.5 in).
Summary of Contents for ITM 470
