Iran Tractor ITM 470, Operators Instruction Book

Page: 18 / 122

1
General information 11
yond the point where the threads begin to
show.
Radiator & cooling system
DO NOT remove the radiator cap when
the engine is running or hot.
DO NOT add coolant to the radiator
while the engine is running.
Before removing the radiator cap, turn
the cap slowly to relieve the pressure.
Service tyres safely
WARNING
Failure to follow the correct procedure
when fitting a tyre on a wheel or rim can
produce an explosion which may result in
serious injury or death.
Do not attempt to fit a tyre unless you
have the proper equipment and experience
to perform the job. Have the work carried
out by ITMCO Dealer or a qualified repair
service.
When sealing tyre beads onto rims,
never exceed 2.4 bar (35 lbf/in) or the
maximum inflation pressure specified by
the tyre manufacturer for fitting tyres.
when using a trailer.
Check the brake fluid reservoir and
top-up as necessary. If the fluid level con-
tinually falls report it to ITMCO Dealer im-
mediately so that the fault can be rectified
(see maintenance section).
Cab
Watch out for children! Always look
behind the tractor to be sure it is safe to
reverse as noise from outside is often not
heard inside the cab.
When a cab is fitted, always close the
doors firmly before moving the tractor.
Keep the windows clean to ensure good
all round visibility.
WARNING
The standard cab filter DOES NOT
provide protection against chemicals,
please refer to the manufacturer’s
information before use.
Keep the cab floor, pedals and foot-
steps clean and clear of debris.
Linkage
The top link must not be extended be-
Before making adjustments or servic-
ing the electrical system, disconnect the
battery cables (negative (-) cable first).
When making repairs or adjustments it
is recommended that you consult ITMCO
Dealer, and have the work carried out by
trained personnel.
General
WARNING
DO NOT use the tractor hydraulics
as a jack or hoist when working on the
tractor or an implement.
The implement and/or tractor must be
supported on suitable blocks or stands,
NOT a hydraulic jack.
Check all nuts and bolts periodically
for tightness, especially wheel hub and
rim nuts.
Check the power steering reservoir (if
fitted) regularly and top-up as necessary
with an ITMCO approved fluid.
Check the brakes regularly, and ad-
just where necessary. Make sure that the
brakes are evenly adjusted, especially