Pag. 9
ENGLISH (Translation of original instructions)
7.6 -
Replacing the belts
7.7
Replacing the flaps
As this operation cannot be carried out with the
machine in working position, carry out the following
operations.
After removing the rear bin, the batteries and the two left and right
bottom casings, lift one side of the machine and tip it up until it is
vertical. Do not do this on the floor but onto material that will prevent
the machine from getting damaged.
Fixed side and rear flaps: loosen the screws that secure the flap retainer
to the machine’s chassis.
- Remove the flap retainer.
- Replace the flap with a new one.
- Put the flap retainer back in place and fasten the screws you
previously removed.
Adjustable front flap: release the clip fastening the flap lifting cable.
- Remove the fixing screws.
- Replace the flap with a new one.
- Put the flap retainer back in place and fasten the screws you
previously removed.
- Fasten the flap lifting cable to the flap.
Fig 5
After loosening the screws that keep the top right casing and bottom
right casing in place, remove the belt from the pulley groove and replace
it with a new one.
When you are replacing the driving belt 18 you must remove the other
belt too, otherwise it will not be possible to carry out this operation.
See the fig. 5.
Before carrying out any work on the machine, make
sure that it is off and that all its functions are disabled.
This is done by turning the key switch 3 fig.3 on the
OFF position.
Before carrying out any work on the machine,
make sure that it is off and that all its functions are
disabled. This is done by turning the key switch
3, fig. 3 OFF.
7.8 - REPLACING AND REGULATING THE FLAP LIFTING
CABLE ( See Fig. 6 )
To replace the flap lifting cable:
-Loosen the machine nose fixing screws and remove the nose.
-Loosen the bumper fixing screws and remove the bumper.
-Loosen the cable clamp 43 fitted to the brake.
-Remove the clip 33 from the flap fork.
-Remove the cable 36.
Reassembling:
-After removing the fork and nut 35 from the broken cable (if they
are in good repair), mount them on the new flap lifting cable.
-Secure the fork to the flap using the clip 33.
-Put the spring 37 onto the cable 36 and slot the cable through the
guide pin 40. Insert the cable 36 into the sheath 49 and then slot
it through the centring pin 47. Insert the cable into the cable clamp
and secure it in place with the other clamp 43.
7.9
REPLACING AND REGULATING THE BRAKE
CABLE. ( See Fig. 7 )
To replace the brake cable:
-Loosen the machine nose fixing screws and remove the nose.
-Loosen the bumper fixing screws and remove the bumper.
-Loosen the cable clamp (61) fitted to the brake.-Pull the cable
out of the pedal, making sure not to loose the brake return spring
60.
Re-assembling:
-Before fitting the cable, loosen the adjustment screws 40.
-After slotting the cable through the cable holder pin 37 located on
the brake pedal, first slot the cable through the centring pin 39, then
through the adjustment screw 40.
-Fit the cable into the sheath 57 and the spring onto the cable.
-Secure the cable in place with the clamp 61.
-Clamp the sheath and cable into the appropriate sheath holding
clamp 55.
-To adjust the braking efficiency, act on the adjustment screws 40
located near the brake lever.
Summary of Contents for 1010 E
Page 1: ...1010 E JET 1000 E 1020 E...
