Pag. 7
ENGLISH (Translation of original instructions)
The life of the battery will depend on its routine maintenance and on
its discharge level.
Do not allow the battery charge to drop below the limit signalled by
indicator light (H Fig.3).
Charge indicator lights
GREEN LIGHT:
the battery is fully charged.
YELLOW LIGHT:
the battery is running out, recha-
rge as soon as possible.
RED LIGHT:the battery has run out. DO NOT
operate the machine.
Every 200 hours of work,check the state of the motor carbon brushes
of every electrical motor and replace them if they are worn.
Always try to replace them before they reach 1000 hours of work.
7.1BATTERY MAINTENANCE The battery must
be kept clean and dry. Keep the terminals and poles
clean.
Every 10 hours,remove the caps and check the electrolyte
level. If necessary top up with distilled water.
The battery should be serviced in a properly ventilated area. During
this operation,do not expose the battery to naked flames and do not
smoke.
The battery has a 4 hours working life;if you notice that it is much
shorter,check that:
* the brushes are not obstructed.
* the battery is completely charged before starting the work.
- ROUNTINE MAINTENANCE -
ALL ROUNTINE MAINTENANCE AND SPECIAL MAINTENANCE MUST BE CARRIED OUT BY COMPETENT PERSONNEL OR BY
AN AUTHORISED SERVICE CENTRE.ALWAYS USE ORIGINAL SPARE PARTS.ALL MAINTENANCE OPERATIONS MUST BE
CARRIED OUT WITH THE MACHINE OFF.
C O N T R O L L I
C H E C K
Controllare liquido batteria
Check the battery liquid
x
x
Controllare l'usura delle cinghie
The belts for slackening
x
Registrare il freno
Adjust the brake's cable
x
Controllare il serraggio di dadi e viti
The tightness of nuts and screws
x
Controllare lo stato delle spazzole
The brushes for wear
x
Controllare la tenuta delle guarnizioni
The gaskets for wear and leakages
x
Controllare il funzionamento di tutte le funzioni
If all the functions are in working order
x
x
Ingrassare la catena dello sterzo
Grase the steering chain up
x
Alla consegna
On delivery
Ogni 10 ore
Every 10 hours
Ogni 50 ore
Every 50 hours
Ogni 100 ore
Every 100 hours
7.2 - FILTER MAINTENANCE
The filter is a component of primary importance for the correct work of
the machine.Its correct maintenance will keep the functioning of the
machine always to the highest levels.
The filter can be cleaned in two ways:
1 - The electric filter shaker
This instrument is simple to use and allows you to keep the filter in
perfect working order. To operate the shaker, push down the switch
2, fig. 3 and hold it down for a few seconds. Repeat the operation 4 or
5 times.Remember that the cleaner the filter, the better the results.
This operation should be carried out after every work cycle.
DUSTY ENVIRONMENT:If you are using the
machine in a particularly dusty environment ( i.e.
warehouses with trucks passing, sawmills, ecc...
remember that the filtershaker should be used more
frequently.
2.
Cleaning the filter manually
In the case in which the cleaning of the filter by the filter-shaker
wouldn't be effective,and every 20 working hours anyway,proceed
with the manual cleaning of the filter.
Before carrying out every operation on the machine,make sure that this
last be switched off and that all of its functions be disactivated,to get
to this state, set the key switch 3 Fig.3 in the OFF position.
1 - Lift the bonnet where the seat is located.
2 - Slacken the wing nut on the filter box cover.
3 - Remove the cover.
Clean the filter blowing with a jet of compressed air directed towards
the waste bin, so that any residual falls into the bin.
Summary of Contents for 1010 E
Page 1: ...1010 E JET 1000 E 1020 E...
