Invacare Spree XT, Owner'S Operator And Maintenance Manual

Page: 64 / 76

SECTION 9—ANTI-TIPPERS
Spree XT
64
Part No 1118364
SECTION 9—ANTI-TIPPERS
WARNING
After any adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Installing/Adjusting Anti-Tippers
NOTE: For this procedure, refer to FIGURE 9.1.
NOTE: A 1 ‐ ½ to 2 ‐ inch clearance between the bottom of the anti ‐ tipper wheels and the floor
MUST be maintained at all times.
NOTE: If any adjustments/replacement of the rear wheels have been made, the anti ‐ tippers must
be adjusted to maintain the 1 ‐ ½ to 2 ‐ inch clearance. If this adjustment cannot be made with the
anti ‐ tippers currently installed, a different model may be required. Consult a qualified technician
for assistance.
Installing
1. Remove the anti ‐ tippers from the accessory carton.
WARNING
Anti-tippers MUST be fully engaged and spring buttons fully protruding out of
adjustment holes.
2. Press the release buttons in and install the anti ‐ tippers into the anti ‐ tipper mounting
brackets.
NOTE: Ensure the wheels are facing down and the locking buttons lock in place.
3. Adjust the anti ‐ tippers. Refer to Adjusting on page 65.