Invacare Spree XT, Owner'S Operator And Maintenance Manual

Page: 47 / 76

SECTION 5—ARMS
Part No 1118364
47
Spree XT
Arm Pad Replacement for Cantilever Arms
NOTE: For this procedure, refer to FIGURE 5.7.
1. Remove the mounting screws from the armrest pad.
2. Replace with NEW armrest pad.
3. Secure with existing hardware.
FIGURE 5.7 Arm Pad Replacement for Cantilever Arms
Installing/Removing T-Arms
NOTE: For this procedure, refer to FIGURE 5.8.
Installing T-Arms
1. Position the T ‐ Arm over the T ‐ Arm
socket on the wheelchair frame.
NOTE: Make sure the locking lever is towards
the front of the wheelchair.
2. Slide T ‐ Arm into T ‐ Arm socket until the
locking lever is in the slot in the T ‐ Arm
socket and an audible ʺ click ʺ is heard.
3. Pull UP on T ‐ Arm to make sure T ‐ Arm
is locked in place.
NOTE: If the T ‐ Arm does not slide in the
T ‐ Arm socket as desired, adjust the T ‐ Arm
socket. Refer to Adjusting T ‐ Arm Sockets on
page 50.
4. Adjust the T ‐ Arm for desired height,
width and depth, if necessary. Refer to
Adjusting The T ‐ Arms on page 48.
5. Repeat STEPS 1 ‐ 4 for opposite side of
wheelchair.
FIGURE 5.8 Installing/Removing T-Arms
Full Length Arm Pads Desk Length
Arm Pads
Armrest Pad
Cantilever
Arm Tube
Mounting
Screws
Cantilever
Arm Tube
Mounting Screws
Arm Pad
Cantilever
Slide Tube
T-Arm
Socket
Locking Lever
(towards the front
of the wheelchair)
T-Arm
Wheelchair
Frame
Slot