Invacare Spree XT, Owner'S Operator And Maintenance Manual

Page: 56 / 76

SECTION 6—BACK/SEAT
Spree XT
56
Part No 1118364
Adjusting
NOTE: For this procedure, refer to FIGURE 6.5.
1. Flip both release levers to the unlocked
position.
2. Adjust stroller handle to desired angle.
3. Flip both release levers to the locked
position.
4. Push down on stroller handle to ensure
release levers hold the desired position
of the stroller handle.
5. If release levers DO NOT hold the
position, tighten the release lever by
performing the following:
A. Flip release lever to the unlocked
position.
B. Rotate thumbscrew clockwise one
revolution.
FIGURE 6.5 Installing/Removing/Adjusting
the Adjustable Angle Stroller Handles
NOTE: When tightening the release lever, the release lever must be able to close completely into the
locked position. Otherwise, the release levers will not hold the desired angle.
C. Flip release levers to the locked position.
NOTE: If the release levers do not close completely into the locked position, rotate the thumbscrew
on each release lever counterclockwise ½ revolution.
D. Repeat STEPS A ‐ C for opposite release lever.
E. Push down on stroller handle to ensure release levers hold the desired position of
the stroller handle.
F. Repeat STEPS A ‐ E until release levers hold the position.
Installing and Removing a Seating System
WARNING
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
TRANSPORT READY OPTION ONLY - This wheelchair has been tested for seat-
ing in a motor vehicle with the factory installed seating system ONLY.
1. Ensure that the seating system is compatible with this wheelchair.
2. Refer to the seating system Owner ʹ s Manual for installation and removal.
Stroller
Handle
Release
Lever
Thumbscrew
Locked Positions