Invacare Spree XT, Owner'S Operator And Maintenance Manual

Page: 43 / 76

SECTION 5—ARMS
Part No 1118364
43
Spree XT
Installing Locking Cantilever Arms
NOTE: For this procedure, refer to FIGURE 5.2.
NOTE: When removing the locknuts and washers from the cantilever arm assembly, leave the top
hex bolt, coved washers and spacer (between adjustment plate and cantilever arm) in place.
1. Slide the partially assembled cantilever arm assembly with mounting hardware
through the back cane. Make sure the adjustment plate is towards the inside of the
wheelchair.
NOTE: This includes top hex bolt, coved washers and spacer (between adjustment plate and
cantilever arm).
2. Slide the bottom hex bolt (w/coved washer) through the adjustment plate and back
cane.
3. Securely tighten the cantilever arm to the wheelchair with two locknuts and washers.
4. Adjust the angle of the cantilever arm, if necessary. Refer to Adjusting Locking
Cantilever Arm Angle on page 44.
Adjusting Locking Cantilever Arm Height
NOTE: For this procedure, refer to FIGURE 5.2.
NOTE: When removing the locknuts and washers from the cantilever arm assembly, leave the top
hex bolt, coved washers and spacer (between adjustment plate and cantilever arm) in place.
1. Remove the two locknuts and washers securing the cantilever arm assembly to the
back cane.
2. Remove the cantilever arm assembly with hardware from the back cane.
3. Perform STEPS 1 ‐ 4 in Installing Locking Cantilever Arms on page 43 to reposition the
arm at the desired height.
FIGURE 5.2 Installing Locking Cantilever Arms - Adjusting Locking Cantilever Arm Height
Locknuts
Washers
Back Cane
Adjustment Plate
Coved
Washers
Actuator
Spacer
Top Hex Bolt and
Coved Washer
Bottom Hex Bolt
Cantilever Arm