Invacare Spree XT, Owner'S Operator And Maintenance Manual

Page: 62 / 76

SECTION 8—WHEEL LOCKS
Spree XT
62
Part No 1118364
SECTION 8—WHEEL LOCKS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Using/Adjusting Wheel Locks
NOTE: For this procedure, refer to FIGURE 8.1.
Using Wheel Locks
1. Push the wheel lock handle forward to engage the wheel locks.
2. Reverse STEP 1 to disengage the wheel locks.
Adjusting Wheel Locks
NOTE: When changing the position of the rear wheels, the wheel locks MUST be repositioned.
NOTE: Before adjusting or replacing the wheel lock assemblies, ensure that the tires are inflated to
the recommended p.s.i on the side wall of the tire.
NOTE: The foot activated wheel locks and the front wheel locks adjust in the same way.
NOTE: If wheel locks need replacement, installation must be performed by a qualified technician.
1. Loosen, but DO NOT remove the two set screws (Detail ʺ A ʺ ) that secure the wheel lock
assembly to the wheelchair frame.
2. Measure the distance between the wheel lock shoe and the rear wheel.
3. Slide the wheel lock along the wheelchair frame until the measurement is between
5/32 and 5/16 ‐ inches.
4. Securely tighten the two set screws (Detail ʺ A ʺ ).
5. Repeat STEPS 1 ‐ 4 for the opposite wheel lock.
6. Engage the wheel locks and push against the wheelchair to determine if the wheel
locks engage the rear wheels enough to hold the occupied wheelchair.
7. Repeat STEPS 1 ‐ 6 until the wheel locks engage the rear wheels enough to hold the
occupied wheelchair.