Invacare Spree XT, Owner'S Operator And Maintenance Manual

Page: 40 / 76

SECTION 4—FRONT RIGGINGS
Spree XT
40
Part No 1118364
Composite/Articulating Footplate Heel Loop
Replacement
NOTE: For this procedure, refer to FIGURE 4.10.
Disassembly
Composite
1. Remove the hex screw and coved
spacer that secure the lower footrest
assembly to the swing away footrest
assembly.
2. Remove the lower footrest assembly.
3. Remove the phillips screw and locknut
that secure the heel loop to the footrest.
4. Slide heel loop off of the footrest.
Articulating
1. Remove the phillips screws, washers
and spacers that secure the heel loop to
the articulating footplate.
FIGURE 4.10 Composite/Articulating
Footplate Heel Loop Replacement
Reassembly
1. Replace heel loop.
2. Reverse the disassembly procedures.
NOTE: When securing the heel loop to the footrest assembly, tighten phillips screw until the spacer
is secure.
Replacing Sector Block
NOTE: For this procedure, refer to
FIGURE 4.11.
1. Remove the hex screw and washer that
secure the existing sector block to the
front rigging support tube.
2. Position the new sector block on the
front rigging support tube. Make sure
the locking pin is facing up.
3. Secure the new sector block to the front
rigging support tube with the existing
hex screw and washer.
FIGURE 4.11 - Replacing Sector Block
Articulating
Footplate
Spacer
Phillips
Screws
Washer
Heel
Loop
Locknut
Heel
Loop
Spacer
Phillips
Screw
Lower Footrest
Assembly
Hex Screw and
Coved Spacer
Swingaway Footrest Assembly
Composite Footplate
Wheelchair
Frame
Locking Pin
Hex
Screw
Washer
Sector Block