Invacare Spree XT, Owner'S Operator And Maintenance Manual

Page: 50 / 76

SECTION 5—ARMS
Spree XT
50
Part No 1118364
Adjusting T-Arm Sockets
NOTE: For this procedure, refer to
FIGURE 5.12.
NOTE: Perform this procedure if the T ‐ Arm is
too loose in the socket or does not easily slide
UP and DOWN in the socket.
1. Remove the rear wheels from the
wheelchair, if necessary. Refer to
Installing/Removing Rear Wheels on
page 65.
2. Loosen, but DO NOT remove the four
hex screws and washers that secure
T ‐ Arm socket to T ‐ Arm clamp.
NOTE: The T ‐ Arm socket will disassemble if
the four hex screws and washers are removed.
FIGURE 5.12 Adjusting T-Arm Sockets
3. Slide the T ‐ Arm into the T ‐ Arm socket until the locking lever is in the slot in the T ‐ Arm
socket and an audible ʺ click ʺ is heard.
4. Squeeze the T ‐ Arm socket and the T ‐ Arm clamp together until the socket is flush with
the T ‐ Arm.
5. While holding the T ‐ Arm socket and the T ‐ Arm clamp together, tighten the four hex
screws and washers. Tighten securely.
6. Press in on the locking lever and lift the T ‐ Arm straight up and out of the T ‐ Arm
socket.
7. Repeat STEPS 3 ‐ 6, if necessary until the T ‐ Arm slides in the T ‐ Arm socket as desired.
8. If necessary, install rear wheels. Refer to Installing/Removing Rear Wheels on page 65.
Hex Screws
and Washers
T-Arm
Hex Screws
and Washers
T-Arm Socket
T-Arm Clamp
Locking Lever
Slot